From: jingluan <jin...@ca...> - 2010-07-01 03:48:12
|
Hi :-) Question 1: I run a muli-mass case, but the log info is not shown in the terminal as it does for a sing-mass case, what's wrong? Here is what comes out: done read_masses 2 2.0000000000000000E-02 mass 1 1.0000000000000000E+00 mass 2 2.0000000000000000E+00 isochrone mass 1 1.0000000000000000E+00 star_log_name: i001_star.log profiles_index_name: i001_profiles.index log_data_prefix: i001_log create pre main sequence model done build_pre_ms_model __________________________________________________________________________________________________________________________________________________ step lg_Tcntr Teff lg_LH lg_Lnuc Mass H_rich H_cntr N_cntr Y_surf X_avg eta_cntr pts retry lg_dt_yr lg_Dcntr lg_Rsurf lg_L3a lg_Lneu lg_Mdot H_poor He_cntr O_cntr Z_surf Y_avg gam_cntr jacs bckup age_yr lg_Pcntr lg_L lg_LZ lg_Psurf lg_Dsurf He_poor C_cntr Ne_cntr Z_cntr Z_avg v_div_cs dt_limit __________________________________________________________________________________________________________________________________________________ save photos/x020 save photos/x040 save photos/x060 save photos/x080 save photos/x100 save photos/x120 save photos/x140 save photos/x160 save photos/x180 Question 2: I add a condition to stop the run at run_star_extras.f (attached ), see the part: if (s% model_number==1) then extras_finish_step=terminate end if but it does not terminate when s% model_number==1 Thank you very much :-) -- Sincerely Jing Ph.D candidate at physics.caltech email: jin...@ca... address: MC350-17,Caltech,1200E.California Blvd, Pasadena, CA 91125 |