Hi :-)
Question 1: I run a muli-mass case, but the log info is not shown in the
terminal as it does for a sing-mass case, what's wrong? Here is what
comes out:
done read_masses 2
2.0000000000000000E-02
mass 1
1.0000000000000000E+00
mass 2
2.0000000000000000E+00
isochrone mass 1
1.0000000000000000E+00
star_log_name: i001_star.log
profiles_index_name: i001_profiles.index
log_data_prefix: i001_log
create pre main sequence model
done build_pre_ms_model
__________________________________________________________________________________________________________________________________________________
step lg_Tcntr Teff lg_LH lg_Lnuc Mass
H_rich H_cntr N_cntr Y_surf X_avg eta_cntr pts retry
lg_dt_yr lg_Dcntr lg_Rsurf lg_L3a lg_Lneu lg_Mdot
H_poor He_cntr O_cntr Z_surf Y_avg gam_cntr jacs bckup
age_yr lg_Pcntr lg_L lg_LZ lg_Psurf lg_Dsurf
He_poor C_cntr Ne_cntr Z_cntr Z_avg v_div_cs dt_limit
__________________________________________________________________________________________________________________________________________________
save photos/x020
save photos/x040
save photos/x060
save photos/x080
save photos/x100
save photos/x120
save photos/x140
save photos/x160
save photos/x180
Question 2: I add a condition to stop the run at run_star_extras.f
(attached ), see the part:
if (s% model_number==1) then
extras_finish_step=terminate
end if
but it does not terminate when s% model_number==1
Thank you very much :-)
--
Sincerely
Jing
Ph.D candidate at physics.caltech
email: jin...@ca...
address: MC350-17,Caltech,1200E.California Blvd,
Pasadena, CA 91125
|
