Just as the error message says, you are not supplying the needed parameter after mcc-lidar.
From: Jangla Mangla [mailto:janglamangla99@users.sf.net]
Sent: Thursday, August 27, 2015 9:40 AM
To: [mcclidar:discussion]
Subject: [mcclidar:discussion] Error: Missing post spacing
Hi,
Congratulations in advance for your great work, and thank you for offering this interesting tool.
I keep having this error while trying to open MCC-LIDAR 2.1:
Error: Missing post spacing
just after typing mcc-lidar in the command prompt. Any solutions, suggestions?
Hi,
Congratulations in advance for your great work, and thank you for offering this interesting tool.
I keep having this error while trying to open MCC-LIDAR 2.1:
Error: Missing post spacing
just after typing mcc-lidar in the command prompt. Any solutions, suggestions?
Thanks,
J.
Just as the error message says, you are not supplying the needed parameter after mcc-lidar.
From: Jangla Mangla [mailto:janglamangla99@users.sf.net]
Sent: Thursday, August 27, 2015 9:40 AM
To: [mcclidar:discussion]
Subject: [mcclidar:discussion] Error: Missing post spacing
Hi,
Congratulations in advance for your great work, and thank you for offering this interesting tool.
I keep having this error while trying to open MCC-LIDAR 2.1:
Error: Missing post spacing
just after typing mcc-lidar in the command prompt. Any solutions, suggestions?
Thanks,
J.
Error: Missing post spacinghttps://sourceforge.net/p/mcclidar/discussion/961944/thread/f9573224/?limit=25#b247
Sent from sourceforge.net because you indicated interest in https://sourceforge.net/p/mcclidar/discussion/961944/
To unsubscribe from further messages, please visit https://sourceforge.net/auth/subscriptions/
Hi J.
Type the following to see usage:
mcc-lidar --help
This is an example with spacing of 1 and curvature threshold of 0.10:
mcc-lidar -s 1.00 -t 0.10 input.las output.las
Hope this helps.
Regards, Cutberto.
Well, this is embarrassing... it turns out it´s not just typing "mcc-lidar" and all works out, parameters are needed. Who would guess.
Thanks Andrew and Cutberto, I hope this post will help other newbies like me.
J.
Last edit: Jangla Mangla 2015-08-28