Recently I try to use matcont toolbox in MATLAB2011a, namely MATLAB 7.12.0 But always shows wrong!
My system is Windows7 home basic 32-bit.
Current directory is E:\Matlab2011a\toolbox\matcont4p2
After searching some LP, H points and plot them in 2Dplot:1, I choose Select-Initial point-H: Hopf-select. And then, click Compute-forward/backward, there is always a dialog:
Error using-feval
Invalid MEX-file
'E:\Matlab2011a\toolbox\matcont4p2\LimitCycle\BVP_LC_jac.mexw32'
The specified module could not be found.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi there,
I also recall to have had this problem. Unfortunately you need to open the MATLAB function that invokes BCP_LC_jac.mex32 and modfiy it accordingly. I recall that it should be quite fast. I might be wrong but either look for an "if" statement or do some basic debugging to figure out what you are missing.
Apparently there is no support from developers for this project any longer. It seems that MATCONT help, which was never very helpful, does not exist any longer. I am not even sure at this point whether this project is still active.
Sorry I cannot be of more help.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Everyone,
Recently I try to use matcont toolbox in MATLAB2011a, namely MATLAB 7.12.0 But always shows wrong!
My system is Windows7 home basic 32-bit.
Current directory is E:\Matlab2011a\toolbox\matcont4p2
After searching some LP, H points and plot them in 2Dplot:1, I choose Select-Initial point-H: Hopf-select. And then, click Compute-forward/backward, there is always a dialog:
Error using-feval
Invalid MEX-file
'E:\Matlab2011a\toolbox\matcont4p2\LimitCycle\BVP_LC_jac.mexw32'
The specified module could not be found.
need help!
Hi there,
I also recall to have had this problem. Unfortunately you need to open the MATLAB function that invokes BCP_LC_jac.mex32 and modfiy it accordingly. I recall that it should be quite fast. I might be wrong but either look for an "if" statement or do some basic debugging to figure out what you are missing.
Apparently there is no support from developers for this project any longer. It seems that MATCONT help, which was never very helpful, does not exist any longer. I am not even sure at this point whether this project is still active.
Sorry I cannot be of more help.