MatCont / Discussion / Open Discussion: How can we change the tolerance for the continuation parameter?

How can we change the tolerance for the continuation parameter?

Forum: Open Discussion

Creator: Anonymous

Created: 2019-07-12

Updated: 2019-07-12

Anonymous - 2019-07-12

I want my active parameter to be perturbed by smaller values. Where do I change that?

Last edit: Anonymous 2019-07-12

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- hilmeijer - 2019-07-12
  
  Time to read the manual: Max/MinStepSize in the Continuer window
  
  From: RV rohini-v@users.sourceforge.net
  Sent: Friday, July 12, 2019 7:13 AM
  To: [matcont:discussion]
  Subject: [matcont:discussion] How can we change the tolerance for the continuation parameter?
  
  I want my active parameter to be perturbed by smaller values. Where do I change that?
  
  How can we change the tolerance for the continuation parameter?
  
  Sent from sourceforge.net because you indicated interest in https://sourceforge.net/p/matcont/discussion/762214/
  
  To unsubscribe from further messages, please visit https://sourceforge.net/auth/subscriptions/
  
  alternate
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Anonymous - 2019-07-12

Oops, sorry. Thank you. I am working with CL_Matcont so, I changed the stepsize in the cont.m file. That should do it.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.