Using a proxim orinoco 8470-wd cardbus card in a laptop (mandrake 10)
got the most recent cvs, make went fine, make install went fine. I created the ifcfg-ath0 file in /etc/sysconfig/network-scripts
Yet ath0 is not recognized. I see the message during bootup "bringing up interface ath0 [OK]"
If I go through the MCC (mandrake control center) under hardware, I can see the card, but the module is listed as "unknown". ifconfig reports eth0 (wired) and lo, no ath0.
I even tried a fresh install of drake 10, no change.
Get latest updates about Open Source Projects, Conferences and News.