Hello to whoever read this topic,
from beautiful "Euro Champion Greece"
I am trying to make a remote configuration tool for Atheros Wireless
and i use madwifi driver.
I found a "bad scenario" trying to configure physical mode.
If i had modified channel/frequency (a/b/g doesn't matter) and then try
to change from one mode to another (e.g from a to b) i had an error from
and i see debug msg "unable to reset channel x (y MHz)"
This happens only if i had set a different channel from the default.
All these happen when in master mode.
I try to put some delay before ath_chan_set function just in case there
was a bad sychronization (driver-firmware) but i couldn't achieve my
The only solution i found is to change to Managed mode and again to
Master.Then i can play to the new band with any channel.
I will be glad to hear any news from some of u guys....
(especially from Portuguese mates)