Using a 1.1 meg DWG file (renamed to testing.dwg to
avoid and possible name related problems) sent by Peter.
$> viewer testfile.dwg
program starts up as a shrunked window, the file
loading bar loads up fine, at the point where it gets
to finished loading the program dies with the command
Opening viewer and then loading the dwg file kills
Peter mentioned that the file loads fine on viewer 0.96
but not on 0.98, or 0.99. Could this be Qt3 related in
This doesn't seem related to the segmentation fault
experienced with the 150mb dxf file problem we had
before. The file Peter had is very small and I
experience no hard disk thrashing loading it. (eg the
swap file wasn't touched)
I've emailed back asking if the DWG's been edited with
any extensions etc.