From: Mitani <mi...@ry...> - 2010-01-20 04:38:00
|
Thank you for your great effort for "make3.80" supporting. But in my system, there are several problems. Because it is necessary to report about them hastily, I report them without investigation first of all. I tried to make with 2010-01-20 version cvs in my several systems. - RHEL5.4 x86 - RHEL5.4 x86_64 - RHEL5.4 ia64 - RHEL4.8 x86 (using make3.80/3.81) - RHEL4.8 x86_64 (using make3.80/3.81) I show below the results. 1) <RHEL5.4 x86> "make" succeeded, but "make install" failed as follows: ------------ mkdir -m 00755 -p "//opt/ltp" mkdir -m 00755 -p "//opt/ltp/bin" make -C "doc" \ -f "/home/LTP/ltp-2010-01-20/doc/Makefile" install make[1]: Entering directory `/home/LTP/ltp-2010-01-20/doc' make[2]: Entering directory `/home/LTP/ltp-2010-01-20/doc/man1' make[2]: *** No rule to make target `/opt/ltp/share/man/man1', needed by `/opt/ltp/share/man/man1/doio.1'. Stop. make[2]: Leaving directory `/home/LTP/ltp-2010-01-20/doc/man1' make[1]: *** [install] Error 2 make[1]: Leaving directory `/home/LTP/ltp-2010-01-20/doc' make: *** [doc-install] Error 2 ------------ 2) <RHEL5.4 x86_64> 3) <RHEL5.4 ia64> 4) <RHEL4.8 x86> (using make3.81) 5) <RHEL4.8 x86_64> (using make3.81) In above systems, results were same as <RHEL5.4 x86>. 6) <RHEL4.8 x86> (using make3.80) Strangely, the "make" command returned immediately. "echo $?" was 0. But log was only several lines as follows: ------------ make -C testcases/realtime autotools make[1]: Entering directory `/home/LTP/ltp-2010-01-20/testcases/realtime' autoheader make[1]: Leaving directory `/home/LTP/ltp-2010-01-20/testcases/realtime' ------------ Is this message same as what is written in the "INSTALL" file? Just in case, I tried "make install". But the result was as follows: ------------ make -C "pan" \ -f "/home/LTP/ltp-2010-01-20/pan/Makefile" install make[1]: Entering directory `/home/LTP/ltp-2010-01-20/pan' test -d "/opt/ltp/bin" || mkdir -p "/opt/ltp/bin" install -m 00775 "/home/LTP/ltp-2010-01-20/pan/ltp-bump" "/opt/ltp/bin/ltp-bump" install: cannot stat `/home/LTP/ltp-2010-01-20/pan/ltp-bump': No such file or directory make[1]: *** [/opt/ltp/bin/ltp-bump] Error 1 make[1]: Leaving directory `/home/LTP/ltp-2010-01-20/pan' make: *** [pan-install] Error 2 ------------ 7) <RHEL4.8 x86_64> (using make3.80) Results were same as <RHEL4.8 x86> (using make3.80). Regards-- -Tomonori Mitani |