I can't get audio output from my Yamaha MG10XU. I was able to access my group's server, adjust settings etc. with no problems at all. The only problem seems to be audio output. I'm connecting by USB through a MacPro.
Last edit: Frank Foley 2021-01-16
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
1) The USB channels are 9 and 10. Make sure the level is turned up on those channel and pan is centered.
2) Make sure the FX for 9 and 10 is turned all the way down or you will loop back to the other jammers.
3) To Mon/St switch must be UP
4) Stereo Mute switch Down
5) Plug into Headphone Jack.
6) Turn stereo Level UP
You will be hearing ONLY the audio returned from Jamulus so you must be connected to a server and your slider must be turned up. Mute Myself can be on or off.
Make sure Steinberg driver is installed and you have selected Yamaha Steinberg USB Audio from the Jamulus Settings window. In that Window, choose ASIO settings and select Device mg-10xu and Mode = Low Latency Driver. I use buffer size 64.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
1) The USB channels are 9 and 10. Make sure the level is turned up on those channel and pan is centered.
2) Make sure the FX for 9 and 10 is turned all the way down or you will loop back to the other jammers.
3) To Mon/St switch must be UP
4) Stereo Mute switch Down
5) Plug into Headphone Jack.
6) Turn stereo Level UP
You will be hearing ONLY the audio returned from Jamulus so you must be connected to a server and your slider must be turned up. Mute Myself can be on or off.
Make sure Steinberg driver is installed and you have selected Yamaha Steinberg USB Audio from the Jamulus Settings window. In that Window, choose ASIO settings and select Device mg-10xu and Mode = Low Latency Driver. I use buffer size 64.
I can't get audio output from my Yamaha MG10XU. I was able to access my group's server, adjust settings etc. with no problems at all. The only problem seems to be audio output. I'm connecting by USB through a MacPro.
Last edit: Frank Foley 2021-01-16
Hi Frank,
Did you connect to a server?
You will not hear anything in Jamulus if you don't connect to a server.
Don
Yes I did. The group I’m with are frequent users of Jamulus so all good on that front. I might revise my post to include that point.
Thanks Don!
Frank Foley
+81 (0) 80 4441 1961
I used an MG10XU as well. Check these settings.
1) The USB channels are 9 and 10. Make sure the level is turned up on those channel and pan is centered.
2) Make sure the FX for 9 and 10 is turned all the way down or you will loop back to the other jammers.
3) To Mon/St switch must be UP
4) Stereo Mute switch Down
5) Plug into Headphone Jack.
6) Turn stereo Level UP
You will be hearing ONLY the audio returned from Jamulus so you must be connected to a server and your slider must be turned up. Mute Myself can be on or off.
Make sure Steinberg driver is installed and you have selected Yamaha Steinberg USB Audio from the Jamulus Settings window. In that Window, choose ASIO settings and select Device mg-10xu and Mode = Low Latency Driver. I use buffer size 64.
Thanks! I’ll double check all these settings.
I think the Steinberg driver is only fr Windows, right? I’m on a Mac.