WinLIRC and LIRC - only raw codes generated

[Ac.Metelka <js...@se...>]

Hello everybody,

I have question about LIRC config to set up hex codes for my Harmony One
remote set as iMon Pad remote, which I had before.

I have my HTPC with "IR Einschalter Rev 5" from www.atric.de as serial IR
receiver. First I used iMon Pad remote with USB receiver to control
Mediaportal, but missed on-off function. With Atric receiver it works, but I
was unable to setup WinLIRC and then also LIRC to learn hex codes.

In WinLIRC I tried several config files for iMon Pad remote, also I tried to
record own config with IRRecord. But I only achieved to have setup for raw
codes. When trying to record codes, I always got "Something went wrong ..."
message.

Then I read in some forum, that LIRC IRRecord is better, so I installed
Ubuntu 12.04 under Oracle Virtualbox and after few hours I was able to use
mode2 and then IRRecord to record commands. But also only in raw mode. I
tried also to use -a parameter for IRRecord, but with no success.

The problem is, that with raw codes, it sometimes work sometimes not, I have
to push button twice etc.

Any idea, what can be wrong? Maybe I should use different protocol in
Harmony setup, but what? Any recomendations? I tried MCE Remote profile, but
result was the same.

Thanks a lot!

Ac.Metelka
-- 
View this message in context: http://old.nabble.com/WinLIRC-and-LIRC---only-raw-codes-generated-tp34810951p34810951.html
Sent from the LIRC mailing list archive at Nabble.com.