From: Jason B. <jas...@ya...> - 2003-06-30 16:05:05
|
Hi, I been searching the forum for answer for the pass two weeks but to no avail. I need to know what are the driver i needed to choose to compile lirc and should the irda module loaded running too? Here is what i did:- ##################################### 1. i loaded irda and stir4200 (Sigmatel usb-irda) module =============================== Module Size Used by stir4200 11120 1 irda 86032 1 [stir4200] e100 68432 1 (autoclean) mousedev 4112 1 hid 17728 0 [mousedev] input 3360 0 [mousedev hid] usb-uhci 21472 0 (unused) usbcore 57120 1 [stir4200 hid usb-uhci] ============================================= 2. dmesg show:- ================================== hub.c: USB new device connect on bus1/1, assigned device number 2 usb.c: USB device 2 (vend/prod 0x66f/0x4200) is not claimed by any active driver usb.c: registered new driver stir4200 SigmaTel STIr4200 IRDA/USB found at address 2, Vendor: 66f, Product: 4200 IrDA: Registered SigmaTel device irda0 USB IrDA support registered ==================================== 3. i run ./setup.sh and try all the listed driver, i even try ./configure --with-driver=any or ./configure --with-driver=none. The issue is other then "./configure --with-driver=none" i cannot do the "make" command. ########################################### I hope to get advise on what should i go about in choosing for my above mentioned device. Thanks in advance ===== Best Regards, J.Benedict __________________________________ Do you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! http://sbc.yahoo.com |