i have to use and irda receiver.
in kernel i can't compile serial as modules ( symbole error in other
modules ) so i included in kernel
isapnp, serial, irda, iradcom. compile ok, lirc with sir module, 0x3F8,
irq4 ok ( compil with new kernel loaded ).
check in /proc/tty, have serial and ircomm
as said, lirc can't load, so setserial /dev/ttyS0 uart none. after lirc
load fine but running mode2, i get all output... without any use of
remote ; same for irrecord.... lircd load, but of course irw print nothing
( the irda receiver was detected by windoze )
what is the right config ???? and for hardware ??? in bios i set :
uart=irda, receive=Lo,Lo, Ir tran delay=Disabled, ur2 duplex mode=half,
use ir pins=ir-rx2tx2
kernel is 2.4.18, lirc 0.6.6, mainboard epox via kt333 ; never get
Please do answer, it's for work, not only for fun.... ( and it hurry )
Get latest updates about Open Source Projects, Conferences and News.