Yesterday i learned about LIRC and tried to make my Fly98 remote control
working. This became a problem.
So i have some questions.
1. What is /dev/lircd
2. What is /dev/lirc
at my place /dev/lirc goes ->/ttyS0, which is incorrect. I have serial
Well, i have get kernel-2.4.19 compiled -- with good enough bttv support
-- xawtv works good, also my /etc/modules.conf adjusted fine too:
I compiled and installed lirc.
Modprobe lirc_gpio (without params) goes without probs, i can see loaded
bttv, lirc_dev and lirc_gpio after that. All this was done while in X
3. Why nothing is working after that and what i did wrong or what i
should do? (i mean lircd starts without errors, runs and dies for
unknown reasons, irrecord says it can't recognize hardware, and with
given -H failes to *_init(), mode2 says that i mistaken and mode2 is for
another kind of devices)
I haven't found needed info (when all is ok, but nothing works :)) on
Get latest updates about Open Source Projects, Conferences and News.