From: Tomasz Grobelny <grotk@po...> - 2003-08-04 22:48:10
I made a receiver based on TFMS 5360 and LM7805 chips and wrote a small
ioperm(port, 7, true);
and it works just fine (I mean it reacts when I'm pressing buttons). Then I
switched the serial port off:
# setserial /dev/ttyS0 uart none
loaded lirc module:
# modprobe lirc_serial
And noticed that I get low state on the power pin of my RS 232 port. This
should not happen I suppose.
When I set high state on the port I still can't receive anything (mode2).
Where can I look for a solution?