helo
i have a problem with my hauppauge wintv primio tv card.
i have installed lircd 0.6.6 and i have load the module lirc_i2c
work all correcty
but if i start lircd i get the following message:
bender@...:/# lircd
bender@...:/# lircd 0.6.6: daemon() failed
lircd 0.6.6: Success
lircd 0.6.6: caught signal
i have test lircd -n and it starts correct. i can start irw too and i get the correct messages if i press a button on my hauppauge remote controller.
any idea ??
i have tested 0.6.4, 0.6.2, too, and get the same failure.
Informations: Slackware 8.1 with kernel 2.4.18
thank you
many greetings
Bernhard Suttner
|