I hope somebody can help me or point me in the correct direction. I get err code -110
P Bell Easy One Notebook: VIA chipset.
Mandrake 8
usb-uhci, usbcore loads fine.
I tried to install a USB mouse, NetGear EA101 (Kaweth) and SlimCam Camera .. all give me the same error when I plug in the device.
messages:
hub.c: USB new device connect on ....
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=15 (error=-110)
Any ideas?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Wrong forum. What you are reporting is nothing to do with the docs, but is instead a problem with the code (or more likely, your hardware / configuration).
Please go to http://www.linux-usb.org, look in the FAQ, read them ALL (especially about "how do I report a problem"), and post at least the mandatory information to linux-usb-users mailing list.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I hope somebody can help me or point me in the correct direction. I get err code -110
P Bell Easy One Notebook: VIA chipset.
Mandrake 8
usb-uhci, usbcore loads fine.
I tried to install a USB mouse, NetGear EA101 (Kaweth) and SlimCam Camera .. all give me the same error when I plug in the device.
messages:
hub.c: USB new device connect on ....
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=15 (error=-110)
Any ideas?
Wrong forum. What you are reporting is nothing to do with the docs, but is instead a problem with the code (or more likely, your hardware / configuration).
Please go to http://www.linux-usb.org, look in the FAQ, read them ALL (especially about "how do I report a problem"), and post at least the mandatory information to linux-usb-users mailing list.