Re: sh: intc - add support for SH7760 V2

[Paul M. <le...@li...>]

On Mon, Jul 30, 2007 at 07:30:42PM +0900, Magnus Damm wrote:
> sh: intc - add support for SH7760 V2
> 
> This patch converts the cpu specific interrupt setup code for sh7760 from
> ipr + intc2 to intc. New vectors are also added to match the information 
> provided by the datasheet.
> 
> Vectors for IRQ4-IRQ7 are enabled by default. Use plat_irq_setup_pins() if 
> pins IRL0-3 should be used in IRLM mode.
> 
> The patch also adds the SIM block to the serial port platform data.
> Version two of this patch fixes MMCIF problems reported by Manuel Lauss.
> 
> Signed-off-by: Magnus Damm <da...@ig...>

Manuel, can you add an Acked-by for this if it works for you and there
are no other visible regressions on your platform? I'll add it to the
2.6.24 queue then, thanks.