booting problem

[driver i. <mod...@ya...>]

Hi All,

       I am new to STLinux which is based on SH , I was working on the
       ST EVAL board where i came cross this boot problem,
       can some one please point where i went wrong,
       below is there error message.

set bootargs console=ttyAS0,115200 ide0=noprobe mem=36m 
bigphysarea=1512 initrd=initrd.bin init=/sbin/init root=/dev/ram0 ramdisk_size=262144
STEVAL-BOARD> bootm a0040000 a05a0000
## Booting image at a0040000 ...
   Image Name:   Linux-2.6.17.14_stm22_0037
   Image Type:   SuperH Linux Kernel Image (gzip compressed)
   Data Size:    1610926 Bytes =  1.5 MB
   Load Address: 84401000
   Entry Point:  84402000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
   Image Name:   ST40 Linux ramdisk
   Image Type:   SH-4 Linux RAMDisk Image (uncompressed)
   Data Size:    2435165 Bytes =  2.3 MB
   Load Address: 88000000
   Entry Point:  88000000
   Verifying Checksum ...
 OK
   Loading Ramdisk to 84dad000, length 0025285d ... OK

Starting kernel console=ttyAS0,115200 ide0=noprobe mem=36m 
bigphysarea=1512 initrd=initrd.bin init=/sbin/init root=/dev/ram0 
ramdisk_size=262144 - 0x009ad000 - 2435165 ...

Linux version 2.6.17.14_stm22_0037 (root@localhost.localdomain) (gcc 
version 4.1.1 (STMicroelectronics/Linux Base 4.1.1-21)) #22 PREEMPT Mon 
May 21 10:48:22 IST 2007
STMicroelectronics STb7100 Reference board initialisation
STb7109 version 3.x
Built 1 zonelists
Kernel command line: console=ttyAS0,115200 ide0=noprobe mem=36m 
bigphysarea=1512 initrd=initrd.bin init=/sbin/init root=/dev/ram0 
ramdisk_size=262144
PID hash table entries: 256 (order: 8, 1024 bytes)
Using tmu for system timer
Console: colour dummy device 80x25
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 24820k/36864k available (2652k
 kernel code, 12024k reserved, 
348k data, 96k init)
PVR=04061100 CVR=30480000 PRR=00009300
I-cache : n_ways=2 n_sets=256 way_incr=8192
I-cache : entry_mask=0x00001fe0 alias_mask=0x00001000 n_aliases=2
D-cache : n_ways=2 n_sets=512 way_incr=16384
D-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
Mount-cache hash table entries: 512
CPU: STb710x
checking if image is initramfs...it isn't (no cpio magic); looks like 
an initrd
Freeing initrd memory: 2378k freed
NET: Registered protocol family 16
Generic PHY: Registered new driver
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NET: Registered protocol family 2
IP route cache hash table entries: 512 (order: -1, 2048 bytes)
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 2048 bind
 1024)
TCP reno registered
bigphysarea: Allocated 1512 pages at 0x84776000.
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
STPIO layer initialised
STMicroelectronics ASC driver initialized
ttyAS0 at MMIO 0xb8030000 (irq = 121) is a asc
ttyAS1 at MMIO 0xb8033000 (irq = 120) is a asc
RAMDISK driver initialized: 16 RAM disks of 262144K size 1024 blocksize
STe100p: Registered new driver
STe101p: Registered new driver
nwhw_config: device not found
ata1: SATA max UDMA/133 cmd 0xB9209000 ctl 0xB9209820 bmdma 0x0 irq 170
ata1: SATA link down (SStatus 0)
scsi0 : sata_stm
Generic ST boards onboard flash device: 0x00800000 (8.0Mb) at 
0x00000000
Onboard_Flash: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x0031
Using buffer write
 method
cfi_cmdset_0001: Erase suspend on write enabled
Creating 3 MTD partitions on "Onboard_Flash":
0x00000000-0x00040000 : "Boot firmware"
ftl_cs: FTL header not found.
0x00040000-0x00140000 : "Kernel"
ftl_cs: FTL header not found.
0x00140000-0x00800000 : "Root FS"
ftl_cs: FTL header not found.
usbmon: debugfs is not available
ST40_start_host_control
ST40_start_host_control proceeding
ST40-ehci ST40-ehci.2: ST EHCI Host Controller
ST40-ehci ST40-ehci.2: new USB bus registered, assigned bus number 1
ST40-ehci ST40-ehci.2: irq 169, io mem 0xb91ffe00
ST40-ehci ST40-ehci.2: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (ST40)
ST40_start_host_control
ST40-ohci ST40-ohci.1: STB7100 OHCI
ST40-ohci ST40-ohci.1: new USB bus registered, assigned bus
 number 2
ST40-ohci ST40-ohci.1: irq 168, io mem 0xb91ffc00
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usb 1-1: new high speed USB device using ST40-ehci and address 2
usb 1-1: configuration #1 chosen from 1 choice
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
pegasus: v0.6.13 (2005/11/13), Pegasus/Pegasus II USB Ethernet driver
usbcore: registered new driver pegasus
eth0: register 'asix' at usb-STB7100_EHCI-1, ASIX AX88772 USB 2.0 
Ethernet, 00:0e:c6:00:00:c8
usbcore: registered new driver asix
usbcore: registered new driver cdc_ether
usbcore: registered new driver net1080
usbcore: registered new driver zaurus
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
stssc
 layer initialized
STMicroelectronics - Coprocessors st231 Init
st-coprocessor-0: No RAM reserved
st231-0 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
st-coprocessor-1: No RAM reserved
st231-1 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
IP-Config: Incomplete network configuration information.
RAMDISK: Compressed image found at block 0

Regards,
Hemanth
       

       
---------------------------------
 Looking for people who are YOUR TYPE?  Find them here!