On Sat, Jun 20, 2015 at 02:55:35PM +0800, Caleb Yu wrote:
> To whom it may interest,
> I am new to linuxptp. I have not able to check on Linux-users archive yet
> since I just recently added due to read access required error.
Archives on Gmane:
http://news.gmane.org/gmane.comp.linux.ptp.devel
http://news.gmane.org/gmane.comp.linux.ptp.user
> I have
> installed linuxptp according to the website but I don't know the commands
> to configure or start it. I searched around a little bit but not able to
> find what I need. It will help a lot if I get to know how to use this
> program. Thank you.
The easiest way to start is like this:
ptp4l -m -q -i eth0
If your MAC only has SW time stamping, then add '-S' to the command line.
Everything else depends on your special requirements, but if you don't
have any, then you also don't need any other options.
HTH,
Richard
|
