Re: [linuxdc-dev] Confused (long)

[Renegade M. <dra...@sp...>]

>{standard input}: Assembler messages:
>{standard input}:66: Error: unknown opcode
>{standard input}:70: Error: unknown opcode

I was getting unknown opcode errors when trying to compile glibc. The fix
was to set --host=sh-linux when doing the configure. I don't know if this
applies to what you are doing, but if so, try that.
                                               -- Dan
  --------------------------------------------------------------------
            "I'm still sane on three planets and two moons."
  --------------------------------------------------------------------
      Daniel Ramaley                  3118 Cottage Grove Ave Apt 8
      dramaley at spatulacity dot cx        Des Moines, Iowa 50311
      http://www.spatulacity.cx/                    (515) 271-5233
  --------------------------------------------------------------------
       WARNING: REDISTRIBUTION OF THIS MESSAGE MAY BE IN
                VIOLATION OF APPLICABLE COPYRIGHT LAWS.
                THIS MESSAGE NOT GUARANTEED Y-TO-K COMPLIANT.