I am running slackware 10 with kernel 2.4.26 on a at7-max2(via) board.
requested info:
kernel version
2.4.26
libraw1 version
0.10.1
which driver: TI PCILynx or OHCI
OHCI
relevant messages from dmesg
ieee1394: Node removed: ID:BUS[0-00:1023] GUID[000a27000269c01d]
ieee1394: Node removed: ID:BUS[0-01:1023] GUID[00508d0000fe1361]
ohci1394: $Rev: 1045 $ Ben Collins <bcollins@debian.org>
PCI: Found IRQ 3 for device 00:0d.0
PCI: Sharing IRQ 3 with 00:10.0
PCI: Sharing IRQ 3 with 00:12.0
ohci1394_0: OHCI-1394 1.1 (PCI): IRQ=[3] MMIO=[e1007000-e10077ff]
Max Packet=[2048]
ieee1394: Host added: ID:BUS[0-00:1023] GUID[00508d0000fe1361]
ieee1394: Node added: ID:BUS[0-01:1023] GUID[000a27000269c01d]
ieee1394: The root node is not cycle master capable; selecting a new root node
and resetting...
sbp2: $Rev: 1074 $ Ben Collins <bcollins@debian.org>
ieee1394: Node changed: 0-01:1023 -> 0-00:1023
ieee1394: Node changed: 0-00:1023 -> 0-01:1023
scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
scsi singledevice 0 0 0 0
scsi singledevice 0 0 1 0
scsi singledevice 0 0 2 0
scsi singledevice 0 0 3 0
scsi singledevice 0 0 4 0
scsi singledevice 0 0 5 0
scsi singledevice 0 0 6 0
scsi singledevice 0 0 7 0
scsi singledevice 1 0 0 0
Vendor: Apple Model: iPod Rev: 1.50
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 29297520 512-byte hdwr sectors (15000 MB)
sda: test WP failed, assume Write Enabled
sda: sda1 sda2
scsi singledevice 1 0 1 0
scsi singledevice 1 0 2 0
scsi singledevice 1 0 3 0
scsi singledevice 1 0 4 0
scsi singledevice 1 0 5 0
scsi singledevice 1 0 6 0
scsi singledevice 1 0 7 0
output of /proc/bus/ieee1394/devices (if available)
Node[0-01:1023] GUID[00508d0000fe1361]:
Vendor ID: `Linux OHCI-1394' [0x080028]
Capabilities: 0x0083c0
Bus Options:
IRMC(1) CMC(1) ISC(1) BMC(0) PMC(0) GEN(0)
LSPD(2) MAX_REC(2048) CYC_CLK_ACC(0)
Host Node Status:
Host Driver : ohci1394
Nodes connected : 2
Nodes active : 2
SelfIDs received: 2
Irm ID : [0-01:1023]
BusMgr ID : [0-63:1023]
In Bus Reset : no
Root : yes
Cycle Master : yes
IRM : yes
Bus Manager : no
Node[0-00:1023] GUID[000a27000269c01d]:
Vendor ID: `Apple Computer, Inc.' [0x000a27]
Capabilities: 0x0083c0
Bus Options:
IRMC(0) CMC(0) ISC(0) BMC(0) PMC(0) GEN(0)
LSPD(2) MAX_REC(2048) CYC_CLK_ACC(255)
Unit Directory 0:
Vendor/Model ID: Apple Computer, Inc. [000a27] / iPod [000000]
Software Specifier ID: 00609e
Software Version: 010483
Driver: SBP2 Driver
Length (in quads): 8
output of lspci
00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600 AGP]
Host Bridge00:01.0 PCI bridge: VIA Technologies, Inc. VT8235 PCI Bridge
00:0d.0 FireWire (IEEE 1394): Texas Instruments TSB43AB23 IEEE-1394a-
2000 Controller (PHY/Link)
00:0e.0 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0
controller] (rev 50)
00:0e.1 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0
controller] (rev 50)
00:0e.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51)
00:10.0 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0
controller] (rev 80)
00:10.1 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0
controller] (rev 80)
00:10.2 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0
controller] (rev 80)
00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/
B/VT823x/A/C/VT8235 PIPC Bus Master IDE (rev 06)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/
8237 AC97 Audio Controller (rev 50)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev
74)
00:13.0 RAID bus controller: Triones Technologies, Inc. HPT374 (rev 07)
00:13.1 RAID bus controller: Triones Technologies, Inc. HPT374 (rev 07)
01:00.0 VGA compatible controller: nVidia Corporation NV20 [GeForce3 Ti
200] (rev a3)
First time I had this problem was when I upgraded to 2.6 kernel same exact
problem but worked originally in 2.4.26 ... so I went back to my old kernel to
find that it didn't work anymore either??? The biggest problem is its not
telling me whats causing the problem. It says its making it device sda /1/2 but
neither are made...
fdisk /dev/sda
Unable to open /dev/sda
Logged In: NO
modprobe sd_mod