Re: [Linux1394-devel] Ohci compliance of CXD3222

[Sebastien R. <Seb...@sy...>]

>>>>> "Bart" == Bart Nabbe <ba...@cs...> writes:

Bart> Unfortunately that version did not resolve the problem, tried with
Bart> different number of nodes on the bus while initializing. Same result as
Bart> ever 0 nodes and it stays in reset.

Bart> I attached the /proc/ohci and kernel messages for this version. Is there
Bart> some code to tweak in the reset phase that might shine some light into
Bart> this matter?

From what I can see, the problem is that you are not receiving the self-id
packets... I don't see anything obviously wrong with your register setting,
except for the fact that your node id is 1 with the valid bit set (which 
should be zero if no other nodes are detected on the bus).

I have noticed that my ohci card doesn't receive the self-id packets
the first time it is initialized after rebooting the computer... have
you tried to load/unload the ieee1394 modules a couple of times ?

-- 
Sebastien Rougeaux
RSISE, The Australian National University