[Linux1394-cvslog] rev 812 - trunk
Brought to you by:
aeb,
bencollins
From: SVN U. <ben...@li...> - 2003-03-05 16:02:07
|
Author: bencollins Date: 2003-03-05 11:01:19 -0500 (Wed, 05 Mar 2003) New Revision: 812 Modified: trunk/sbp2.c Log: Fix SBP-2 comments concerning hotplug of SCSI devices. Patch from Christoph Hellwig. Modified: trunk/sbp2.c ============================================================================== --- trunk/sbp2.c (original) +++ trunk/sbp2.c 2003-03-05 11:01:20.000000000 -0500 @@ -27,30 +27,8 @@ * driver. It also registers as a SCSI lower-level driver in order to accept * SCSI commands for transport using SBP-2. * - * The easiest way to add/detect new SBP-2 devices is to run the shell script - * rescan-scsi-bus.sh (or re-load the SBP-2 driver). This script may be - * found at: - * http://www.garloff.de/kurt/linux/rescan-scsi-bus.sh - * - * As an alternative, you may manually add/remove SBP-2 devices via the procfs with - * add-single-device <h> <b> <t> <l> or remove-single-device <h> <b> <t> <l>, where: - * <h> = host (starting at zero for first SCSI adapter) - * <b> = bus (normally zero) - * <t> = target (starting at zero for first SBP-2 device) - * <l> = lun (normally zero) - * - * e.g. To manually add/detect a new SBP-2 device - * echo "scsi add-single-device 0 0 0 0" > /proc/scsi/scsi - * - * e.g. To manually remove a SBP-2 device after it's been unplugged - * echo "scsi remove-single-device 0 0 0 0" > /proc/scsi/scsi - * - * e.g. To check to see which SBP-2/SCSI devices are currently registered - * cat /proc/scsi/scsi - * - * After scanning for new SCSI devices (above), you may access any attached - * SBP-2 storage devices as if they were SCSI devices (e.g. mount /dev/sda1, - * fdisk, mkfs, etc.). + * You may access any attached SBP-2 storage devices as if they were SCSI + * devices (e.g. mount /dev/sda1, fdisk, mkfs, etc.). * * * Module Load Options: |