Re: [Linux-gpib-general] problems with RH 9.0 and Measurement Computing PCI Board

[Frank M. H. <fm...@us...>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Monday 19 May 2003 06:26 pm, Neil Phipps wrote:
> Hi All,
>
> I've used GPIB/HPIB a lot in the past (>5 years ago). Subsequently I've
> done a lot of work with Linux (at SGI).  I'm now trying to get the
> Measurement Computing PCi Board to run with RH Linux 9.0 ... I'm gettin=
g
> everything to work just fine for make etc.  Even insmod/modprobe
> installs the cb7210 module OK (checked using lsmod).
>
> BUT, when I try ibtest I get the strangest result ...
>
> > [root@localhost examples]# ./ibtest
> > Do you wish to open a (d)evice or an interface (b)oard?
> >         (you probably want to open a device): d
> > enter primary gpib address for device you wish to open [0-30]: 2
> > trying to open pad =3D 2 on /dev/gpib0 ...
> > Segmentation fault
>
> I checked the code for the changes in cb7210 etc and I guess everything
> is up to date in 3.1.93 ,,, so I think I must be doing something silly
> ... any body have any suggestions ?
>

Well, you should be using cbi_pci as the board_type instead of=20
cbi_pci_accel, unless you have the 1 megahertz version of the board.  You=
=20
still shouldn't get a segfault though.  Would you send me the output of=20
'lspci -v'?

- --=20
Frank

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE+ykbY5vihyNWuA4URAlrjAKCwiNhJFpiFqGaHnzJmOV74HUUKfQCePwJn
S7JVdnum9pPSdaIsy8g/QYM=3D
=3DqQDX
-----END PGP SIGNATURE-----