Re: [Linux-gpib-general] ibBoardOpen errno=2

[Michael T. <Mic...@s3...>]

Thanks that has helped but now I get

minor 0 ioctl 200
minor 0 ioctl 201
minor 0 ioctl 202
minor 0 ioctl 5
gpib: ioports are already in useGPIB Hardware Error! (Chip type not 
found or wrong Base Address?)

Can I set the base address by changing the jumbers on the board to any 
address? If not how do I find a suitable address?

Thanks for your help,

Michael

frank mori hess wrote:

> 
> Michael,
> 
> Note the interface{} section describing your board in your /etc/gpib.conf
> is entirely commented out (the config file respects c-style comments /**/
> ).
> 
> Frank
> 
> 
> _______________________________________________
> Linux-gpib-general mailing list
> Lin...@li...
> https://lists.sourceforge.net/lists/listinfo/linux-gpib-general
> 



-- 
Michael Thompson       	+353 1 291 1710
RF IC Design Engineer  	+353 1 676 3199
Silicon & Software Systems