Re: [Linux-fbdev-users] problems configuring 1280x720 w radeon

[Torgeir V. <to...@po...>]

On Fri, 2004-07-02 at 20:01 +0100, Torgeir Veimo wrote:
> I am trying to configure a 1280x720 resolution at 50Hz with a radeon
> 9100 QM card.

> /var/log/messages at boot time;

And dmesg output, for completeness;

radeonfb_pci_register BEGIN
radeonfb: probed DDR SGRAM 131072k videoram
radeonfb: mapped 16384k videoram
radeonfb: Invalid ROM signature 0 should be 0xaa55
radeonfb: Retreived PLL infos from BIOS
radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=250.00 Mhz,
System=200.00 MHz
1 chips in connector info
 - chip 1 has 2 connectors
  * connector 0 of type 2 (CRT) : 2300
  * connector 1 of type 4 (DVI-D) : 4200
Starting monitor auto detection...
radeonfb: I2C (port 1) ... not found
radeonfb: I2C (port 2) ... not found
radeonfb: I2C (port 3) ... not found
radeonfb: I2C (port 4) ... not found
radeonfb: I2C (port 2) ... not found
radeonfb: I2C (port 4) ... not found
radeonfb: I2C (port 3) ... not found
radeonfb: I2C (port 4) ... not found
radeonfb: Monitor 1 type CRT found
radeonfb: Monitor 2 type no found
radeonfb: ATI Radeon QM  DDR SGRAM 128 MB
radeonfb_pci_register END

I am using the analog connector on this card, connected to a Sanyo PLV
Z2 projector. It advertises wrong EDID data when in PC mode. I can only
get it to advertise 1280x720 on the DVI port, but then I am restricted
to 60Hz, to get a tearing free picture. This is why I am using the
analogue port.

-- 
Torgeir Veimo <to...@po...>