Sorry for a very non-technical question but I've just installed LinPac on a Raspberry Pi Model B running Raspbian 11 (bullseye).
I realised after starting LinPac that I put the wrong parameters in at this point. As a completely non-technical person, can someone tell me where the default parameters are stored and/or what file I can remove/rename in order to re-start LinPac from the beginning again?
Thanks for your help.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello John,
The files are stored in the "LinPac" directory of the user that started the Linpac process. So, if you were running it as root, look in /root/LinPac. If you want to completed start over as if Linpac was never run, run the command "rm -Rf /root/LinPac" and that directory and all contents will be removed.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Sorry for a very non-technical question but I've just installed LinPac on a Raspberry Pi Model B running Raspbian 11 (bullseye).
I realised after starting LinPac that I put the wrong parameters in at this point. As a completely non-technical person, can someone tell me where the default parameters are stored and/or what file I can remove/rename in order to re-start LinPac from the beginning again?
Thanks for your help.
Hello John,
The files are stored in the "LinPac" directory of the user that started the Linpac process. So, if you were running it as root, look in /root/LinPac. If you want to completed start over as if Linpac was never run, run the command "rm -Rf /root/LinPac" and that directory and all contents will be removed.
Thank you David - that's done the trick.