AMDFreak - 2018-02-01

Hi Bob,
You have to setup the kernel ax25 stack to use Linpac. Without a properly configured ax25 port Linpac is mostly useless.

Regards,
Sascha DL3SC

----- Nachricht beantworten -----
Von: "Robert Cheek" n4rfc@users.sourceforge.net
An: "[linpac:discussion] " 54078@discussion.linpac.p.re.sf.net
Betreff: [linpac:discussion] Configuring for Serial connection to PK-232 TNC
Datum: Do., Feb. 1, 2018 01:46

Looked over the docs and the Forum and don't see anything on how to configure the Linpac for using a serial port for a PK-232 TNC. How do I do that ? I was able to complile and install and the program runs but doesn't listen cause nothing is configured.
Regards,
Bob - N4RFC

Configuring for Serial connection to PK-232 TNC

Sent from sourceforge.net because you indicated interest in https://sourceforge.net/p/linpac/discussion/54078/

To unsubscribe from further messages, please visit https://sourceforge.net/auth/subscriptions/

 
alternate