Re: [Libmesh-users] error while configuring libmesh 1.6.2

[INTURU S. 2. <int...@vi...>]

Hi John,
IBAMR open software recommended libmesh 1.6.2.
I sent a config.log file in the first email and this is from the libmesh
directory. Is this the file you need? I am sending it again. Please
find the attachment

Thanks and regards
Srinivas

On Thu, Aug 31, 2023, 01:56 John Peterson <jwp...@gm...> wrote:

> Hi,
>
> Is there a particular reason that you are trying to use libmesh 1.6.2?
> It's about two years old at this point, and there have been many updates
> and improvements (including a stable release) since that time, so you will
> probably have the most success if you use a more up-to-date version.
>
> The log you attached is the output of configure to the terminal, so it
> doesn't really give much information other than:
> <<< Could not find a viable PETSc Makefile to determine PETSC_CC_INCLUDES,
> etc. >>>
>
> You might be able to get more detailed info about the failure to find
> PETSc by looking at the config.log file generated by configure.
>
> --
> John
>
>
> On Wed, Aug 30, 2023 at 5:49 AM INTURU SRINIVAS 20PHD0548 via
> Libmesh-users <lib...@li...> wrote:
>
>> In continuation to the previous mail, I am sending the tasks done while
>> configuring libmesh 1.6.2. The error is mentioned in this file. Please
>> find
>> the attached file and do the needful.
>
>

-- 
**Disclaimer:*
This message was sent from Vellore Institute of Technology.  
The contents of this email may contain legally protected confidential or 
privileged information of “Vellore Institute of Technology”.  If you are 
not the intended recipient, you should not disseminate, distribute or copy 
this e-mail. Please notify the sender immediately and destroy all copies of 
this message and any attachments. If you have received this email in error, 
please promptly notify the sender by reply email and delete the original 
email and any backup copies without reading them.*