Re: [Libmesh-users] Configuring libMesh with Vtk

[Simone R. <sim...@gm...>]

I had a similar issue with libMesh not using the specified VTK installation.
This problem was solved by configuring VTK with MPI, using the VTK configuration option

-D VTK_Group_MPI:BOOL=ON

I hope it helps,

Simone


On Mar 15, 2019, at 11:22, John Peterson <jwp...@gm...> wrote:

> On Fri, Mar 15, 2019 at 10:17 AM Nikrouz <nik...@gm...> wrote:
> 
>> Dear all,
>> 
>> When I want to run FEMsystem example No.2, it is asked me to configure
>> libMesh with --enable vtk. I have configured libMesh(opt and dbg) by
>> these commands but I faced same error.
>> 
>> What Should I do? Thanks for your consideration!
>> 
> 
> Most likely configuring with VTK failed for some reason. You can look at
> the config.log file to find out exactly why, although it can be hard to
> find the right information because there's a lot of info there. Libmesh's
> configure also prints a summary at the end so you can see what features are
> enabled/disabled before continuing to build in an incorrect configuration.
> 
> -- 
> John
> 
> _______________________________________________
> Libmesh-users mailing list
> Lib...@li...
> https://lists.sourceforge.net/lists/listinfo/libmesh-users