From: Thomas Koninckx <tkoninck@es...> - 2005-08-12 12:42:47
I'm using a reset handler ( raw1394_set_bus_reset_handler(...) ) which,
as a test, simply prints an error whenever a bus reset occurs.
If I use dc1394_setup_capture, so non-DMA mode, everything works fine.
However when using dc1394_dma_setup_capture the reset handling seems to
be ignored. When I use a camera which is independently powered I can
pull out the cable (the code freezes at the point where the grab
occurs), and restart my grabbing loop by simply plugging it in again.
The reset is never printed. The latter only illustrates that things not
just block before the call to the reset handler.
I've been crawling around in the coriander code, which convinces me that
this actually should work. I however can't find why things are not
working correctly within my own project. Any suggestions? All hints will
Get latest updates about Open Source Projects, Conferences and News.