Hi Ulf,
[I'm CCing this to the mailing list]
> We are using the same Nexcom Hardware.
Grreat stuff, isn't it?
> Can you please provide any Information about the Wiring-Config
> You use for your LCD?
Well, I've got a 0.10 aka CVS .conf only, and I removed all the Wiring
stuff from it, because with the current CVS, the LCM-162 (that's the
internal display interface) has been built into the driver as a "Model",
and uses hard-wiring.
UTSL says:
if ((SIGNAL_RS = drv_generic_parport_hardwire_ctrl ("RS",
"SELECT"))==0xff) return -1;
if ((SIGNAL_RW = drv_generic_parport_hardwire_ctrl ("RW",
"INIT" ))==0xff) return -1;
if ((SIGNAL_ENABLE = drv_generic_parport_hardwire_ctrl ("ENABLE",
"AUTOFD"))==0xff) return -1;
if ((SIGNAL_ENABLE2 = drv_generic_parport_hardwire_ctrl ("ENABLE2",
"GND" ))==0xff) return -1;
if ((SIGNAL_GPO = drv_generic_parport_hardwire_ctrl ("GPO",
"GND" ))==0xff) return -1;
so the wiring sould be:
RS <=> SELECT
RW <=> INIT
ENABLE <=> AUTOFD
ENABLE2 <=> GND
GPO <=> GND
Note that this wiring is for 0.10 aka CVS, that's because RW is wired to
INIT, and we're using busy-flag checking (whcih saves us a lot of CPU load)
Maybe you wanna try 0.10 anyway.
bye, Michael
--
Michael Reinelt <re...@eu...>
http://members.eunet.at/reinelt
GPG-Key 0xDF13BA50
ICQ #288386781
|
