Re: [Isisalsa-devel] Any tester available ?

[Felipe S. <sol...@es...>]

Felipe Sologuren wrote:
> Jeanseb wrote:
> 
>> I need test for the current cvs driver.
>>
>> What i need exactly is :
>>   First test with this procedure
>>        -run "maxiinit isis.bin " where maxiinit is the "old" tool and 
>> isis.bin
>> taken from windows driver. you may have two strange response.
>>        - start alsa.
>>        - configure output volume and start player.
>>        - you should have all voice playing the same stuff (mix done by 
>> the
>> firmware from ess output).
>>
> 
> Ok!
> First test was:
>     -maxiinit isis.bin (with alsa pre-load) (0 strange responses)
>         -start alsa (won't work, strange noises)
>     -stop alsa manually
>     -maxiinit isis.bin manually (2 strange responses)
>     -modprobe -r snd-page-alloc
>     -maxiinit isis.bin manually (0 strange responses & noise off)
>     -modprobe snd.es1968 (ok!)
>     -it sounds all outputs very good. It sounds all rack inputs no 
> matter mixer levels.
> 
> dmesg1-isis was the dmesg from the that boot & test.
> 
> Obs: That was the maxiinit produced with main.cpp from 2004-04-09


     -first test with the maxinit produced with main.cpp from 2005-04-25

	-excelent (works with hot boot). I think previous strange responses 
were because I have 2 cards compiled. When the other is bios disabled 
then loading on boot works ok.

     -second test with HOT boot.

	Module loaded succesfull, loading firmware reports  WRONG UART MODE ACK 
0!!! loop=5fff (see attach). No sound :-(
	If I run maxiinit after, then the card sounds ok.

pending:
	-second


Felipe