I'm a little frustrated with this. I have read the documentation about how to use a file from GMSH, but I do not know what to do.
Somebody can tell me how can to do it?
I make the geometry in GMSH, I meshed it, and saved like...... or, save the mesh directly, without changed format?
Once saved, I opening the file .msh with Impact, and now....I need to save in format .in, before to apply material, load, etc... or in pre-processor can apply material, etc...and then save like .in?
Please, is possible an step by step.....for me is very important to use GMSH to draw (mainly glass)
Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everybody,
I'm a little frustrated with this. I have read the documentation about how to use a file from GMSH, but I do not know what to do.
Somebody can tell me how can to do it?
I make the geometry in GMSH, I meshed it, and saved like...... or, save the mesh directly, without changed format?
Once saved, I opening the file .msh with Impact, and now....I need to save in format .in, before to apply material, load, etc... or in pre-processor can apply material, etc...and then save like .in?
Please, is possible an step by step.....for me is very important to use GMSH to draw (mainly glass)
Thank you