Hi,
I have just installed impact 0.7.06.040 on a windows 64 bit machine. I also have Autodesk fusion 360 and several other autodesk products installed.
I am able to open impact and then load file (e.g. 3.in. or plate.in) the geometry appears in the pre-processor.
I ran the processor and it seems to run completely to the end.
When I load the flavia.res file, I cannot see any graphical results nor any timesteps.
When I load the flavia.res file in notepad, I can see lots of data there. GID seems to show the results as well.
Any ideas?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I have just installed impact 0.7.06.040 on a windows 64 bit machine. I also have Autodesk fusion 360 and several other autodesk products installed.
I am able to open impact and then load file (e.g. 3.in. or plate.in) the geometry appears in the pre-processor.
I ran the processor and it seems to run completely to the end.
When I load the flavia.res file, I cannot see any graphical results nor any timesteps.
When I load the flavia.res file in notepad, I can see lots of data there. GID seems to show the results as well.
Any ideas?
When you open result, use the filter
Files of Type: select "Open solver result *.res"
Thank you so much. This fixed it. Much appreciated!