I think I discovered a bug in the acutal IFC Exporter. I changed the coordinates in my revit project and then exported via Basepoint. However once I link the IFC File into Revit it shows completely twisted. Using the general Exporter it works fine. Any ideas?
The geometry in that image looks very strange. Is the geometry very far from the origin (like, >20km?) That can cause big problems in Revit. You might have to move the geometry closer to the origin and then export again.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I think I discovered a bug in the acutal IFC Exporter. I changed the coordinates in my revit project and then exported via Basepoint. However once I link the IFC File into Revit it shows completely twisted. Using the general Exporter it works fine. Any ideas?
is there any idea about this issue?
The geometry in that image looks very strange. Is the geometry very far from the origin (like, >20km?) That can cause big problems in Revit. You might have to move the geometry closer to the origin and then export again.