When I export a floor that has been joined to another floor the geometry does not seem to export correctly. I am using Revit 2018 v18.4.0 exporter. However when I use Revit 2019 v19.1.0.112 for the same (upgraded) file the geometry exports correctly (see image).
I am using the same settings of just exporting current view only but even when I export the entire model the geometry is not correct.
Any assistance greatly appreciated. Image and files attached. There are a number of floor types with different layering structures to test whether that was the issue but I can't seem to figure it out.
Hi there,
When I export a floor that has been joined to another floor the geometry does not seem to export correctly. I am using Revit 2018 v18.4.0 exporter. However when I use Revit 2019 v19.1.0.112 for the same (upgraded) file the geometry exports correctly (see image).
I am using the same settings of just exporting current view only but even when I export the entire model the geometry is not correct.
Any assistance greatly appreciated. Image and files attached. There are a number of floor types with different layering structures to test whether that was the issue but I can't seem to figure it out.
Cheers
Mark
I'll check it out, Mark. Did you make sure you have the latest open source for 2018? (is that a dumb question considering you're here?)
Hi Andy,
Apologies just seen your response, have you had a chance to look at this? Yes the exporter versions are as stated above.
Revit 2018 - v18.4.0
Revit 2019 - v19.1.0.112
Many thanks
Mark
Hi Andy,
Apologies just seen your response, have you had a chance to look at this? Yes the exporter versions are as stated above.
Revit 2018 - v18.4.0
Revit 2019 - v19.1.0.112
Many thanks
Mark