Re: [Iaxclient-devel] Crash w/ IAXComm talking to another IAXComm

[Nathan S. <iax...@np...>]

Michael,
  Thanks so much for the quick reply!  To answer your questions, I am 
calling through an Asterisk 1.0.1 server (with Speex disabled).  I am 
not using the echo cancellation feature. 

  Could this be the same problem?
http://sourceforge.net/mailarchive/forum.php?thread_id=5836576&forum_id=29380

  Only the existence of NAT or not doesn't seem to matter for me.  I 
have hooked up my asterisk server to a FWD account using iax2.fwdnet.net 
and I've found that the client crashes also if I try to connect to FWD 
through my asterisk server.  

Feature Requests?  My top priorities, in order:
1) Secure against malicious incoming packets
2) Low Latency (10-2004 version seems much better than the earlier 
version, when it doesn't crash).
3) Reliable.  The earlier version has never crashed yet on me, it just 
has much higher latency.
4) Easy to install/use (so I can hand it out to family and friends).  
You are pretty close on this front already.  There are a couple of minor 
GUI issues which could be cleaned up.
5) Control over the encoding format

And as an aside for later: Some type of network level encryption would 
be great (if it didn't make latency bad).

  Thanks again!
   Nathan

Michael Van Donselaar wrote:

>
>Are you calling peer-to -peer (XP to RH8), or are both phones registered with an
>asterisk server?
>
>Do you have echo cancel turned on?  I think there's still a problem in there.  I
>probably ought to disable that.
>
>  
>
>
>Feature requests are welcome too!
>  
>