Re: [hpoj-devel] OJ 700 Progress

[<pa...@rc...>]

Hi, James.

James Klicman wrote:
> I noticed that the SetReply exec_out is not always OK, sometimes it is
> ErrorActionCanNotBePerformedNow. The PML Protocol Specification refers
> to the PML Object Specification to determine why this happened and how
> to get the device into the correct state for the SetRequest.
> 
> Can you please send me the PML Object Specification?
I'm not at liberty to send that out, but if you have specific questions about
specific OIDs, then I might be able do some research for you.  Which OIDs
were you getting that error on?  If you're referring to the SCAN-UPLOAD OID,
I couldn't find any such state recovery information about it.  I do know that
the other OIDs which are used for setting up scan parameters can only be set
when SCAN-UPLOAD is set to 1 (idle), so that could be causing the problem,
especially if the driver crashes during the scan and you don't reset it to
idle before the next scan attempt.

David