[hpoj-devel] Printer driver installation problems

[<mab...@ya...>]

Hi again:

I think I am at the end of the configuration-
installation of this OfficeJet driver.

However I need your help.

1. I checked the following in the step "Loading the
parallel port drivers (notes and troubleshooting":

# cat ../ANNOUNCE | /opt/hpoj-0.6/scripts/addcr >
/dev/lp0

and the printer exhibited the "stair-step" effect.
Is it a normal situation? (The Install notes say that
"addcr" script may help).

2. I wrote the following command:
# /usr/local/bin/hpo get OID_CFG_STATUS

and I received the message:
Error while executing request: 0x83
<Error Unknown Object Identifier>

Then, I asked some help to the computer:
# hpo --help

and it said: get <object id>

What was the correspondig id?

3. I read the mail: "Printing in RedHat Was..."
written by Joe Piolunek, because I installed RedHat in
my computer.

I achieved all the steps, except the following
instructions:
#!/bin/sh
The computer answer:
bash: !/bin/sh: event not found

Also I tried:
# sh filename: /var/spool/lpd/HPOJ_DRV/wrapfilter
and I received another error message.

Note: I know the "!" character is employed to use a
command again with a specific model.

I suppose these 2 comands
QUEUEDIR=....
IEEE12844DIR=....

must be written inside the file wrapfilter. Is it
correct? May I use vi?

Where do I write the last command:
${QUEUEDIR}/filter...?

Really, sorry for this last question, but remember I
am a beginning with Linux and Unix.

Thanks in advanced.

Marco Becerril


_________________________________________________________
Do You Yahoo!?
Obtenga su dirección de correo-e gratis @yahoo.com
en http://correo.espanol.yahoo.com