[hpoj-devel] Problem with configuring HP Officejet 6110 all-in-one software

[Jack D. <cas...@ad...>]

I am running SuSE 9.2 Pro and have the HP Officejet rpm installed. I
can't get it configured.  It works on (ugh) Windows but even Windows
won't give me the actual USB serial device it is using.

usbview gives me a message that states
 Error /proc/bus/usb/devices does not exist.


The ptal-init setup command fails as listed below. My question is "How
can I get it installed?"

Jack Denman

************************************

lanya:~ # ptal-init setup

Stopping the HP OfficeJet Linux driver.

----------------------------------------------------------------------

This program manages devices controlled by the HP OfficeJet Linux
driver (hpoj).  It attempts to probe your computer for local parallel-
and USB-connected devices, and allows you to specify network addresses
for remote JetDirect-connected devices.

If you experience any difficulties in detecting your device(s), then
refer to the hpoj documentation for troubleshooting information.

----------------------------------------------------------------------

Currently defined device names ([*]=default):
    (none)

----------------------------------------------------------------------

Probe for parallel-connected devices ([y]/n)?  n

----------------------------------------------------------------------

Probe for USB-connected devices ([y]/n)?  y

Probing "/dev/usb/lp0"...
    No device found.

Probing "/dev/usb/lp1"...
    No device found.

Probing "/dev/usb/lp2"...
    No device found.

Probing "/dev/usb/lp3"...
    No device found.

Probing "/dev/usb/lp4"...
    No device found.

Probing "/dev/usb/lp5"...
    No device found.

Probing "/dev/usb/lp6"...
    No device found.

Probing "/dev/usb/lp7"...
    No device found.

Probing "/dev/usblp0"...
    No device found.

Probing "/dev/usblp1"...
    No device found.

Probing "/dev/usblp2"...
    No device found.

Probing "/dev/usblp3"...
    No device found.

----------------------------------------------------------------------

Press <Enter> alone to continue, or if you would like to add a
JetDirect-connected device, then enter its dotted-decimal
IP address or hostname here --->

----------------------------------------------------------------------

Done updating device configuration files stored under /etc/ptal.
If you make manual changes to those files, then be sure to run
"/usr/sbin/ptal-init start" so they will take effect.

----------------------------------------------------------------------

Starting the HP OfficeJet Linux driver.
    No hpoj devices have been configured.
    As root, run "/usr/sbin/ptal-init setup".

lanya:~ #                                                          

-- 
Jack Denman <cas...@ad...>