Re: [hpoj-devel] scanning and printing problem with hpoj-0.91

[Cory M. <cor...@hp...>]

Under YaST which port are you selecting? If you want to print and scan
at the same time, you must use the ptal port and not the USB port.

Cory
hp linux printing team


On Fri, 2004-07-02 at 15:43, Christian Schramm wrote:
> Hello!
> 
> I'm new to this list. I've got some huge problems using the hpoj drivers 
> on Suse 9.0 pro with my PSC 950.
> My english is not the best, so I hope you can understand my problems...
> 
> A longer time ago I compiled the 0.90 drivers and installed them. 
> Everything worked fine...almost.
> The printer worked, even the card reader (using mtools).
> But as soon as I scan something, the printer doesn't work anymore. I had 
> to plug the USB cord off and in again, then setup the printer again with 
> YaST2. Then I was able to print again.
> 
> After some frustration because of this I decided to install the 0.91 
> version of the drivers.
> 
> Now I can scan, use the card readers but I'm not able to print anymore.
> Only if I plug off the USB cord for some seconds and then plug it in 
> again (hardware detection), then setup the printer with YaST2, I can 
> print.....
> After a reboot the printer doesn't work anymore and ptal-mlcd shows an 
> error message at boot. Then I have to do all the same things again...
> 
> I think this is an issue with the drivers..........isn't it?
> 
> Best regards
> 
> Christian
> 
> 
> 
> 
> -------------------------------------------------------
> This SF.Net email sponsored by Black Hat Briefings & Training.
> Attend Black Hat Briefings & Training, Las Vegas July 24-29 - 
> digital self defense, top technical experts, no vendor pitches, 
> unmatched networking opportunities. Visit www.blackhat.com
> 
> _______________________________________________
> hpoj-devel mailing list
> hpo...@li...
> https://lists.sourceforge.net/lists/listinfo/hpoj-devel