Hi
I've tried to create some segments. For example :
MSH msh =3D null;
msh =3D new MSH(msg);
msh.getFieldSeparator().setValue("|");
msh.getEncodingCharacters().setValue("^~\\&");
msh.getSendingApplication().getNamespaceID().setValue("ORMED");
msh.getReceivingApplication().getNamespaceID().setValue("PYXISRX");
How must i declare the variable msg and how i can add this segment to a
message?
Thanks in advance.
Regards
Didier
Didier Bosson
Unilog USR S.A.
Chemin des coquelicots 16
CH - 1214 Vernier
t=E9l. : +41 (0) 22 706 29 00
fax : +41 (0) 22 706 29 01
e-mail : did...@ch...
http://www.unilog-usr.ch
***********************************************************************
This message is confidential; its contents do not constitute a
commitment by UNILOG except where provided for in a written agreement
between you and UNILOG . Any unauthorised disclosure, use or
dissemination, either whole or partial, is prohibited. If you are not
the intended recipient of the message, please notify the sender
immediately.
***********************************************************************
|
