These instructions are specific to the STC90C516RD µC.
After configuring the board setup (each example could need some specific wire up), before you can test the program, you have to download the program first and Flash it into the micro-controller.
Note: Please refer to Software Installation Guide.pdf for detailed instructions.
If the installation is successful, a communication port will appear on the Windows Device Manager after the Development board is connected to your PC, similar as the image below:
Please check if the development board settings are correctly setup:
When the development board is connected to the computer with the USB cable power is supplied to it.
Note: If using the USB Flash programming feature, do not use the > optional ISP flash feature (the 10 pin ISP connector on the > development board). These are mutually exclusive operations!
Open the X:\Part 2 Installation\Flash Software\stc-isp-15xx-v6.86E.exe Flash burning software (for details refer to Software Installation Guide.pdf), and be sure to setup the following settings:
If the flash procedure was successful, the following will appear:
Note: The main trick for this CPU is to press the Download/Program button and then press the Power button.