Re: [Hamlib-developer] hamlib Icom IC-7851 and IC-705 WSJTX

[George B. <geo...@gm...>]

Strange, as none of the WSJT-X audio goes through hamlib, but direct to 
the rig.  May be a problem with setting the audio source - I don't 
remember any changes to that but I'll look into it.

One thing to check - I had a similar problem (not with either of your 
rig types, but with a TS-890S) where I thought there was no audio to the 
rig, but there was, only 30-40dB down from where it should be.  I could 
just barely hear it with the rig's monitor function.  Resetting the aux 
input gain cured the problem. You might check the levels or do the audio 
setup from scratch.

Since you're compiling from source, are you using the git repo or the 
tarballs? If it's git, doing a 'git bisect' of the problem would really 
help us diagnose the problem.

73 n3gb

On 6/12/25 11:36 AM, Manfred Antar (KN6KBS) wrote:
> The recent changes to the icom files have broken the
> wsjtx from working on my IC-7851 and IC-705
> The wsjtx recognizes the the radio and outputs the switching
> between Transmit and receive. But no transmit audio is getting to the radio.
> The last version og hamlib that works for me is:
>
>
>
> This is on a MacPro 2019 Intel.
> I compile hamlib and wsjtx from source.
> Not sure where the problem is as there were quite a few changes to the Icom rig files.
> Thanks for all your work !!!
> Manfred
> 73
>
>
> _______________________________________________
> Hamlib-developer mailing list
> Ham...@li...
> https://lists.sourceforge.net/lists/listinfo/hamlib-developer