[Hamlib-developer] IC7300 set CW speed fails on low speeds

[Sakari N. <sak...@ni...>]

While testing changes to Cqrlog cw interface I found out that rigctld 
fails when setting low speed WPMs.
Is it firmware or rigctld bug?

Setup:

ICOM IC7300 firmware ver. 1.41
Fedora 39
rigctld Hamlib 4.6~git 2024-08-07T22:26:03Z SHA=3b1283 64-bit
/usr/local/bin/rigctld  -m 3073 -r /dev/icom7300 -t 4532 -s 19200 -C 
auto_power=0 --vfo -vvvvv -Z >/tmp/rig7300log.txt 2>&1

Presets:
Set rig to CW
Push "Multi"
Select "KEY SPEED" from display
Rotate "MULTI" knob to set minimum key speed (= 6WPM)

telnet localhost 4532

[saku@hamtpad ~]$ telnet localhost 4532
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
L currVFO KEYSPD 7    Rig display shows 6 WPM
RPRT 0
L currVFO KEYSPD 8    Rig display shows 8 WPM
RPRT 0
L currVFO KEYSPD 9    Rig display shows 8 WPM
RPRT 0
L currVFO KEYSPD 10    Rig display shows 9 WPM
RPRT 0
L currVFO KEYSPD 11    Rig display shows 10 WPM
RPRT 0
L currVFO KEYSPD 12    Rig display shows 11 WPM
RPRT 0
L currVFO KEYSPD 13    Rig display shows 13 WPM
RPRT 0
L currVFO KEYSPD 14    Rig display shows 14 WPM
RPRT 0
L currVFO KEYSPD 15    Rig display shows 15 WPM
RPRT 0
L currVFO KEYSPD 14    Rig display shows 14 WPM
RPRT 0
L currVFO KEYSPD 13    Rig display shows 13 WPM
RPRT 0
L currVFO KEYSPD 12    Rig display shows 11 WPM
RPRT 0
L currVFO KEYSPD 11    Rig display shows 10 WPM
RPRT 0
L currVFO KEYSPD 10    Rig display shows 9 WPM
RPRT 0
L currVFO KEYSPD 9    Rig display shows 8 WPM
RPRT 0
L currVFO KEYSPD 8    Rig display shows 8 WPM
RPRT 0
L currVFO KEYSPD 7    Rig display shows 6 WPM
RPRT 0
L currVFO KEYSPD 6    Rig display shows 6 WPM
RPRT 0
q
RPRT 0
Connection closed by foreign host.


I attach also rigctld debug file.

Any comments?

-- 
Saku
OH1KH