Re: [Hamlib-developer] hamlib errors after execution

[Black M. <mdb...@ya...>]

You need to run this:
rigctld -m 4
That will allow you to connect to rigctld on port 4532 which will then talk to FLRig.
Mike W9MDB

 

    On Saturday, March 9, 2024 at 12:08:10 AM CST, Justin Tabatchnick <jus...@co...> wrote:  
 
 
Platform – Raspberry pi 3

OS -Raspian

Radio – FT 857D

Sound Card – Signallink

Rig control  - Flrig

  

Hi 

  

This is a shot in the dark and I’m hoping you can help me or at least point me in the right direction. Below is the output I get after executing direwolf -p > direwolferror.txt. Both Hamlib and direwolf have been successfully installed.

  

###################################################################

Dire Wolf version 1.7

Includes optional support for:  hamlib cm108-ptt dns-sd

  

Reading config file direwolf.conf

Audio device for both receive and transmit: plughw:1,0  (channel 0)

Channel 0: 1200 baud, AFSK 1200 & 2200 Hz, A+, 44100 sample rate / 3.

Hamlib determined CAT control serial port rate of 0.        Is this ok , to have serial port rate = 0? 

Retrying Hamlib Rig open... Don’t understand what it’s looking for here and why it can’t connect

Retrying Hamlib Rig open...

Retrying Hamlib Rig open...

Retrying Hamlib Rig open...

Retrying Hamlib Rig open...

Hamlib Rig open error -6: network_open: failed to connect to localhost:4532   Is 4532 correct ?

rig_open: rs->comm_state==0?=0

 1:rig.c(1023):rig_open returning(-6) IO error

  

 1:rig.c(817):rig_open entered

rig_settings_get_path: path=/home/justin/.config//home/justin/hamlib_settings  hamlib_settings does not exist  was it missed during installation?

rig_settings_load_all: settings_file (/home/justin/.config//home/justin/hamlib_settings): No such file or directory

rig_open: cwd=/home/justin

rig_open: /home/justin/.config//home/justin/hamlib_settings does not exist

rig_open: async_data_enable=0, async_data_supported=0

rig_open: using network address localhost:4532

network_open: hoststr=localhost, portstr=4532

network_open: Using IPV6

connect to localhost:4532 failed, (trying next interface): Network error 111: Connection refused Don’t know what these errors are?

connect to localhost:4532 failed, (trying next interface): Network error 111: Connection refused

network_open: failed to connect to localhost:4532

rig_open: rs->comm_state==0?=0

 1:rig.c(1023):rig_open returning(-6) IO error Don’t know what this error is 

  

IO error

  

###########################################################################################

  

  

Thanks in advance for your help . If you need more information , don't hesitate .

  

Justin Tabatchnick

  

  
_______________________________________________
Hamlib-developer mailing list
Ham...@li...
https://lists.sourceforge.net/lists/listinfo/hamlib-developer