Re: [Hamlib-developer] 'M' and 'm' commands question

[Dave B <g8k...@go...>]

Many HF Kenwood's support setting/getting the RX BW settings (and some, 
also the TX BW settings too)
The TS-870s I have next to me being one such.

It works well with Hamlib, but mostly I use Flrig, even via Hamlib!

73.

Dave G8KBV


On 09/01/2024 15:54, Alexander Anipkin wrote:
> Command 'm' always returns a default value independent of real filter 
> width.
> Command 'M' doesn't change filter width.
> I have checked the kenwood config files
> The functions "kenwood_set_filter_width" and 
> "kenwood_get_filter_width" are only for TS-480 transceivers.
> But the same commands are used for TS-590S(G) to set/get CW filters value.
>
> image.png
>
> Also I found vy strange command in ts590.c config 
> file: "SF%d%011.0f%c". I can't find the SF command in ts590 CAT manual.
> There are SH/SL commands but not SF
> image.png
>
> I hope you see the problem.
>
>
> Best regards
> Alexander
>
>
>
> вт, 9 янв. 2024 г. в 17:55, Alexander Anipkin <ale...@gm...>:
>
>     Ok, thank you
>
>     For TS-590S it doesn't work.
>     Always 2200 for LSB/USB and 500 for CW. I believe it's default values.
>
>
>
>     Best regards
>     Alexander
>
>
>
>     вт, 9 янв. 2024 г. в 17:02, Black Michael <mdb...@ya...>:
>
>         Yes -- a value of -1 will not change the passband.
>
>         What rig are we talking about?
>
>         Mike W9MDB
>
>
>
>
>
>
>
>
>         On Tuesday, January 9, 2024 at 02:57:58 AM CST, Alexander
>         Anipkin <ale...@gm...> wrote:
>
>
>
>
>
>         Hello
>
>         Am I right that in command
>         M, set_mode 'Mode' 'Passband'
>         parameter 'Passband' - is a width of filter for this mode?
>
>         Best regards
>         Alexander
>
>
>         _______________________________________________
>         Hamlib-developer mailing list
>         Ham...@li...
>         https://lists.sourceforge.net/lists/listinfo/hamlib-developer
>
>
>
> _______________________________________________
> Hamlib-developer mailing list
> Ham...@li...
> https://lists.sourceforge.net/lists/listinfo/hamlib-developer

-- 
Sent from a MicroSoft free zone: