Re: [Hamlib-developer] How to get/set TX Power

[Outlook(SV2AGW) <sv...@ou...>]

Hi

Thank you. It Works fine.

Tested it and is ok Yaesu FTDX-10, ICOM IC-7300

ICOM IC-7610  on rig_mW2power returns -10. Is it ok to proceed ignoring the error?

73

(SV2AGW) George Rossopoulos
Anakreontos 14
GR-54250 Thessaloniki
GREECE
www.sv2agw.com
www.frinos.com
www.agwtracker.com








in hamlib this is two steps:

- use rig_mW2power() to convert a power (in milli-Watts) to "some internal unit"

- use rig_set_level to set the power

sample code (int pow is the input), note the "conversion" is frequency-dependent
but for most rigs it is OK to take the conversion in the 20m band

value_t val;
unsigned int mwpower;
freq_t freq;
float fpow;


fpow=pow;
mwpower=1000*pow;
freq=kHz(14000);
rig_mW2power(rig, &fpow, mwpower, freq, RIG_MODE_CW);
val.f=fpow;
rig_set_level(rig, RIG_VFO_CURR, RIG_LEVEL_RFPOWER, val);


And, do not use AM but FM.


> Am 28.06.2023 um 17:30 schrieb Yahoo (sv2agw) via Hamlib-developer :
>
> Hi
> I am trying to write an easyTune like app.
> In brief it will switch to FM or AM mode set Power Output to 15W and PTT for 15secs.
> How to get/set TX Power?
> 73
> (SV2AGW) George Rossopoulos
> Anakreontos 14
> GR-54250 Thessaloniki
> GREECE
> www.sv2agw.com
> www.frinos.com
> www.agwtracker.com
> _______________________________________________
> Hamlib-developer mailing list
> Ham...@li...
> https://lists.sourceforge.net/lists/listinfo/hamlib-developer

+---------------------------------+----------------------------------+
| Prof. Christoph van Wüllen | Tele-Phone (+49) (0)631 205 2749 |
| RPTU, Dpt. of Chemistry | Tele-Fax (+49) (0)631 205 2750 |
| Erwin-Schrödinger-Str. | |
| D-67663 Kaiserslautern, Germany | |
+---------------------------------+----------------------------------+
| HomePage: https://chem.rptu.de/en/wgs/ag-van-wuellen |
+---------------------------------+----------------------------------+